For some reason the leads are not switching polarity.
2000 jeep cherokee drivers door window stuck down.
Have a 2000 grand cherokee.
This leads me to believe that it is not the motor this time.
When the door panel is off and the switch is manipulated then it works for almost 2 or 3 days and then again nothing works.
4 hours ago i left my house responding to a 2 car mva with entrapment and power lines down ended up having to shut down the whole road so when i rolled up i rolled my windows down about an hour later i had to run to get more road flares cause i ran out i got back and lit them but the wind was blowing towards the jeep so i closed the windows but the drivers side crawled up then got stuck.
Get 1 2 pieces of wood 1 foot long is fine that will serve as braces for holding the window in place from the inside of the door you can also use painter s tape.
Yesterday we pulled into a parking lot closed the passenger door and watched the window go down all by itself.
If the window goes up but not down most likely the switch.
The problem was that the upper window track cable pulled through the plastic track guide.
Driver side operates fine.
Get two pieces of wood.
Window rolled down but won t come back up.
Reset the express up module for the door window glass in question.
Among the windows the remote door lock mirror and light does not work at all.
Meter d the leads to the motor and i m getting 12v rolling down but not rolling up.
Actually moves up and down a little bit.
The drivers switch is the master switch and not like the others.
Get inside the car and open the door as you are holing the window switch down slam the door shut a few times sometimes this will jar the window motor loose if it is stuck.
Same issue using both the front and rear window switches.
So the same problem reemerged on the same window.
This is a way to troubleshoot door locks windows door switches in any jeep cherokee wrangler liberty from 1999 2005.
The motor sounds and by the partial movement appears to be working properly.
I purchased a brand new motor and installed it but the same problem is occuring.
If it works ok now the window motor is.
Drove home with the window down in 100 degree heat and decided to fix it the next day.
The alarm can not be activated.
I have a problem with my 2000 jeep cherokee.
You will need to hold the window up once you remove the screws of the regulator mechanism so that the window does not fall off the regulator mechanism.
Disconnect the window from the motor.
The window will go down but not up and will only respond to the passenger front button and not the master button on the driver side.
The drivers side window is stuck open again.
The passenger front window will not go up.
Drive the glass into the full up position by pulling up on the window switch to its second detent manual mode and holding switch until the glass is fully closed.
It will go down but not up.
It seems this would the solution to my grand cherokee 98.